On December 1st 2015 (ahead of schedule) “Mechatronica-Pro” has finished delivery of training equipment in form of Training testbench of type 3 with aggregate consisted of induction motor - dc motor to "Far Eastern State Transport University" (FESTU) located in Khabarovsk, Russia. The equipment has been delivered under the contract for the supply of training equipment for department «Electrical Engineering, Electronics and Electromechanics». November 27th 2015 to December 1st2015 the above mentioned equipment has been mounted and installed and the personnel of the department has been trained to operate with the testbench equipment and MexBIOS Development Studio software platform.
In addition to the equipment delivery an employee of “Mechatronica-Pro” has conducted introductory workshop for students of the department. The workshop has been conducted on November 30th, 2015 for 4th year students that study in direction 140400.62 «Power engineering and electrical engineering» and specialization “Electric drive and automatics”. The MexBIOS Development Studio development environment of embedded software have been shown to the students on example of debugging board STM32F3DISCOVERY and small dc motor. Total number of the workshop participants was 15 persons among which were both students and their teachers. Students have catched on the environment operation at once and by the end of the workshop one of the student has developed a program that controls dc electric drive on debugging board with use of LED-indication and controls. The training set, which had been used during the workshop, was presented to the department for further trainings.